| OSEPP UNO R3 Plus |
1 |
| 6 feet USB type A to mini-B |
1 |
| Tact push switch 6mm x 6mm – through hole |
2 |
| DIP switch 4 position – through hole |
1 |
| 1K ohm potentiometer (variable resistor) – long pins |
1 |
| 10K ohm potentiometer (variable resistor) – long pins |
1 |
| 330 ohm axial resistor, 1/2W, 5% |
20 |
| 1 k ohm axial resistor, 1/2W, 5% |
5 |
| 10k ohm axial resistor, 1/2W, 5% |
5 |
| LED through hole – Red, 8.7mm height, ~2V drop, ~10-20mA |
2 |
| LED through hole – Yellow, 8.7mm height, ~2V drop, ~10-20mA |
2 |
| LED through hole – Green, 8.7mm height, ~2V drop, ~10-20mA |
2 |
| LED through hole – White, 8.7mm height, ~2V drop, ~10-20mA |
2 |
| LED through hole – Blue, 8.7mm height, ~2V drop, ~10-20mA |
2 |
| Two digits 7-segment LED – RED |
2 |
| Buzzer, 5Vo-p |
1 |
| NPN transistor |
2 |
| Breadboard – 30 columns x 14 rows (include 2 VCC and 2 GND) |
1 |
| Ribbon Jumper Cables |
40 |
| 9 Volt Battery Connector |
1 |
| 2cm x 2cm x 3mm thick double side tape |
2 |
| Information sheet – Arduino UNO diagram + basic electronic theory |
1 |
| Really nice Kit container | 1 |