STEPPER MOTOR 12VDC 60mA (ANGLE 7.5° / 48 STEPS)

KP35FM2-035
MOTOR STEPPER 1.8DEG/STEP W/WIRE

Stock Number:
2621-AA1

---

Manufacturer: Japan Servo Co. Ltd.Step Angle: 1.8 degreesWinding Voltage: 12-24 VoltsResistance per Phase: 37 OhmsCoil Winding: Bi-polarNumber of Steps: 200Amperage per Phase: 0.6 AmpsHolding Torque: 700 grams / cmNumber of Leads: 4, Phase One Blue/Red, Phase Two Yellow/WhiteBody...More

11-SHBX-51KT H347
MOTOR STEPPER .312A 1.8DEG W/WIR

Stock Number:
2621-AA2

---

Stepper Motor Current per phase : .312 A. Phase per step : 1.8 degress Wires attached....More

K158
STEPPER MOTOR BIPOLAR DRIVER KIT

Stock Number:
2065-MA1

---

This kit will drive a bi-polar stepper motor driver using externally supplied 5V levels for steping and direction.These usually come from software running in a computer. Construction:- Follow the overlay on the PCB. Add the lowest height components first, e.g. the resistors and d...More

2730767
MOTOR STEPPER 5VDC 40MA W/WIRE RATIO 1:64

Stock Number:
2621-EA1

---

MOTOR STEPPER 5VDC 40MA W/WIRE RATIO 1:64A stepper motor is an electro-mechanical device which converts electrical pulses into discrete mechanical movements. The shaft or spindle of a stepper motor rotates in discrete step increments when electrical command pulses are applied to ...More

STEPD-01
STEPPER MOTOR 4 PHASE & DRIVER MODULE

Stock Number:
1814-LE1

---

Stepper Motor & DriverThe ULN2003A stepper motor board is used to control 4 phase bipolar stepper motors such as the 28BYJ-48 stepper motor.Features:100% Arduino CompatibleULN2003A driver chipcontrols uni-polar & bipolar stepper motors...More

MTD-01
MOTOR DRIVER MODULE L298N 4 WIRE STEPPER OR 2 DC MOTORS

Stock Number:
1814-LD1

---

Motor Driver ModuleCan drive a 4-wire stepper motors, or two DC motors simultaneously for your Arduino project. Ability to control motor direction and speed when used with an Arduino. 100% Arduino Compatible L298 dual h bridge driver Reverse motor polarity (motor direction) The d...More

WPI401
STEPPER MOTOR DRIVER 5V ULN2003 WITH STEPPER MOTOR 5VDC

Stock Number:
1814-LC1

---

A small and versatile motor and driver set. This 5 VOLTS DC stepper motor controlled by the ULN2003 driver can be used with any Arduino® or compatible boards via jumper leads. Four-phase LED indicates the status of the stepper motor. Features ...More

WPI409
MOTOR DRIVER MODULE L298N 4 WIRE STEPPER OR 2 DC MOTORS

Stock Number:
1814-LB3

---

This module allows full control of two DC motors or one stepper motor. Specifications driver: L298Ndriver power supply: + 5 V to + 35 Vdriver output current (max.): 2Alogic power output Vss: +5 V to +7 V (internal supply +5 V)logic curren...More