The OSEPP Motor and Servo Shield can plug directly onto the Arduino and Arduino compatible boards.
- 2 servo motors and 4 bi-directional DC motors with individual 8-bit speed
- 2 servo motors and 2 stepper motors (uni-polar or bipolar) with single
coil, double coil or interleaved steppin
Can use motors operating
between 4.5V to 25V DC.
Servo header and terminal blocks are provided for easy connection to motor. The servo power supply and motor power supply can be configured to source from an individual terminal block or from the Arduino board VIN pin providing flexibility to your project.
Includes two L293D Quad H-Bridges chip-set that can provide 0.6A per
bridge (1.2A peak) with thermal shutdown protection, internal kickback
Provides DIP sockets to support other pin compatible motor bridge
Integrated pull down resistor to keep motor disabled during start up.
Individual LED indicator for motor power supply state and servo
power supply state.
Brings out the Arduino reset button to the top of the shield.
OSEPP Motor & Servo Shield Schematic