11-SHBX-51KT H347
MOTOR STEPPER .312A 1.8DEG W/WIR

Stock Number:
2621-AA2

---

Stepper Motor Current per phase : .312 A. Phase per step : 1.8 degress Wires attached....More

K158
STEPPER MOTOR BIPOLAR DRIVER KIT

Stock Number:
2065-MA1

---

This kit will drive a bi-polar stepper motor driver using externally supplied 5V levels for steping and direction.These usually come from software running in a computer. Construction:- Follow the overlay on the PCB. Add the lowest height components first, e.g. the resistors and d...More

K179
STEPPER MOTOR UNIPOLAR DRIVER

Stock Number:
2065-MA2

---

This kit is a circuit for driving 5, 6 or 8-wire uni-polar stepper motors. It can operate either freestanding or PC-controlled.The circuit and stepper motor may use separate supply voltages. Four high current IRFZ44 MOSFETs are used at the output. The motor can either be stepped ...More

2730767
MOTOR STEPPER 5VDC 40MA W/WIRE RATIO 1:64

Stock Number:
2621-EA1

---

MOTOR STEPPER 5VDC 40MA W/WIRE RATIO 1:64A stepper motor is an electro-mechanical device which converts electrical pulses into discrete mechanical movements. The shaft or spindle of a stepper motor rotates in discrete step increments when electrical command pulses are applied to ...More

STEPD-01
STEPPER MOTOR 4 PHASE & DRIVER MODULE

Stock Number:
1814-LE1

---

Stepper Motor & DriverThe ULN2003A stepper motor board is used to control 4 phase bipolar stepper motors such as the 28BYJ-48 stepper motor.Features:100% Arduino CompatibleULN2003A driver chipcontrols uni-polar & bipolar stepper motors...More

MTD-01
MOTOR DRIVER MODULE L298N 4 WIRE STEPPER OR 2 DC MOTORS

Stock Number:
1814-LD1

---

Motor Driver ModuleCan drive a 4-wire stepper motors, or two DC motors simultaneously for your Arduino project. Ability to control motor direction and speed when used with an Arduino. 100% Arduino Compatible L298 dual h bridge driver Reverse motor polarity (motor direction) The d...More

WPI401
STEPPER MOTOR DRIVER 5V ULN2003 WITH STEPPER MOTOR 5VDC

Stock Number:
1814-LC1

---

A small and versatile motor and driver set. This 5 VOLTS DC stepper motor controlled by the ULN2003 driver can be used with any Arduino® or compatible boards via jumper leads. Four-phase LED indicates the status of the stepper motor. Features ...More

WPI409
MOTOR DRIVER MODULE L298N 4 WIRE STEPPER OR 2 DC MOTORS

Stock Number:
1814-LB3

---

This module allows full control of two DC motors or one stepper motor. Specifications driver: L298Ndriver power supply: + 5 V to + 35 Vdriver output current (max.): 2Alogic power output Vss: +5 V to +7 V (internal supply +5 V)logic curren...More

MOTS2
STEPPER MOTOR 12VDC 60MA

Stock Number:
2621-JA4

---

STEPPER MOTOR 12VDC 60mA (ANGLE 7.5° / 48 STEPS) ...More