FTDI BREAKOUT BOARD 3.3 OR 5V FT232RL C-TYPE TTL SERIAL MODULE
Part No:
Manufacturer:
Stock No: 1815-BB2
SKU No: 270120

Image is for illustrative purposes only. Please refer to product description.
Stock may not be available at all store locations. Inventory quantites can change without notice.
FTDI
TTL Module FT232RL Serial Converter FTDI USB To TTL Converter Adapters
5V 3.3V USB To Serial Converter FT232 FTDI Module 6 Pin Header
This
USB to TTL serial adapter is ideal for many uses, including:
programming microprocessors such as ARM, AVR; working with computing
hardware like routers and switches; serial communication with many
devices including GPS devices or serial terminals on devices like
Raspberry Pi.
Unlike most USB to TTL serial adapters, this adapter
supports both 5V and 3.3V operation! Simply set the jumper as required
to choose between 5V and 3.3V as labelled on the board.
The FTDI
adapter comes with a fitted right-angle connector allowing you to use it
straight away. If you need to access any of the other inputs or outputs
of the FT232RL, all the useful signals are provided as through-hole
solder pads – ideal for use with straight headers into a breadboard, for
example.
Features:
- Product performance: Standard
interface , compatible with a variety of For Official Controller
OriginalFT232Chip, stable performance With power , sending, receiving
indicator , working status Have 3.3V And 5V Power supply options Do
ordinary USB Serial TTL Modules, download STCSCM
- Introduction FT23R
- With
the development of computer technology , parallel and serial ports on
the PC slowly disappeared , and now even the parallel port of the
desktop are rare . But for engineers, parallel and serial interfaces are
essential , especially in the serial . For computers without serial
ports , the most convenient solution is to use USB to serial chip to
virtual serial port out , many manufacturers have produced such a chip ,
such as silicon LABS of CP210x series , TI ‘s TUSB3410, Nanjing Qin
Heng CH34x series, FTDI’s FT232 series , Prolific ‘s PL230x series, Echo
‘s ARK3116 so on. From the stability point of view, the most reliable
or FT232 series , you can use it to ease the debugging process without
fear of a blue screen appears.
- FT232R chip is a single-chip
solution , generally do not need to use basic peripherals , and even
crystal , USB matching resistor , place the product information have
been integrated in the internal EEPROM of the . FT232R There are some
more useful features, details can be found FT232R data sheet .
- Datasheet Download : www.ftdichip.com/Products/ICs/FT232R.htm
- Introduction: hardware
- using FTDI FT232RL chip companies ;
- FT232RL chip lead all the signal port , TTL / CMOS level ;
- RXD / TXD Transceiver Communications LED ;
- USB -powered, 5V or 3.3V
Pin functionality
- DTR – Reset the other hardware device
- RX – Used to receive the serial data.
- TX – Used to transmit the serial data.
- VCC – Provides 5V or 3.3V voltage output as per the requirement
- CTS – Enable or disable the programming mode of the device
- GND – Ground pin
- Support 3.3V, 5V
- Chipset: FT232RL
- USB power has over current protection, using 500MA self-restore fuse
- RXD/TXD transceiver communication indicator
- Pin definition: DTR,RXD,TX,VCC,CTS,GND
- Pitch:2.54mm
- Module Size: About 36mm(length)*18mm(width)
- Interface : C